Desa CGF280PT User Manual download pdf (Page 10)

102665

INSTALLING

Continued

ASSEMBLING AND ATTACHING BRASS TRIM

Note:

The instructions below show assembling and attaching brass trim to fireplace.

Do not yet install brass trim if performing a built-in installation (See Built-In

Fireplace Installation, page 13).

1. Remove packaging from three pieces of brass trim.

2. Locate four brass screws, two adjusting plates with set screws, and two shims

in the hardware packet.

3. Align shim under adjusting plate as shown in Figure 5.

4. Slide one end of adjusting plate/shim in slot on mitered edge of top brass trim

(see Figure 5).

5. Slide other end of adjusting plate/shim in slot on mitered edge of side brass

trim (see Figure 5).

6. While firmly holding edges of brass trim together, tighten both set screws on

the adjusting plate with slotted screwdriver.

7. Repeat steps 1 through 6 for other side.

Figure 6 - Attaching Brass Trim to Fireplace

Side Brass Trim

Top Brass Trim

Slot

Mitered Edge

Slot

Shim

Set Screws

Adjusting

Plate

Trim Hanging

Screws

Assembled

Brass Trim

8. Tighten trim hanging screws (#10 x 6.25 shoulder) into holes in cabinets.

Place the assembled trim onto fireplace cabinet. Align hanging notches on

trim with hanging screws on side of fireplace (see Figure 6). Push trim firmly

into place, sliding hanging notches over hanging screws.

Figure 5 - Assembling Brass Trim

Hanging

Notches on

Trim

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

No comments

Desa CGF280PT User Manual Page 10