Desa CGESS User Manual download pdf (Page 5)

www.desatech.com

117889-01B

5

Most halogen light bulbs are rated to last approxi-

mately 1800 hours. Like all light bulbs, halogen

bulbs require periodic replacement. When the

bulbs in your unit have burned out you will notice

or more of the following:

• Flame is dim or dark in certain areas

• Log set ember bed appears dim or dark in

certain areas

WARNING: Do not install

replacement bulbs that exceed

speciﬁed maximum watts.

CLEANING AND

MAINTENANCE

Continued

Figure 4 - Replacement Light Bulb

Your unit must be opened in order to replace the

light bulbs. To reduce the number of times you

need to open the unit, replace all bulbs at the

same time if they are close to the end of their

rated life.

Tools Required: Phillips Screw Driver

Replacing Flame Generation Bulb

1. Unplug unit from the power supply.

2. Remove the six screws from the back of stove

as shown in Figure 5. Remove back plate.

3. Locate the flame generation cylindrical

drum (see Figure 6). It is constructed of two

removable halves. They are two matte black

sheet-metal pieces with holes in them, either

of which can be removed from the unit.

4. Squeeze half of drum cylinder until its top

edge clears the top drum track. Remove the

bottom edge of the cylinder drum from the

bottom drum track. This will give you access

to the light bulbs.

Note: Do not exert exces-

sive pressure on the drum cylinder as this may

cause damage.

5. Remove spring clip. Hold socket and pull out

old bulb.

6. Hold socket and push in new bulb. Replace

spring clip.

7. Insert bottom edge of removed cylinder half

into bottom of drum track. Gently squeeze

drum cylinder until it's top edge ﬁts into top

drum rack.

Figure 5 - Screw Locations

Screws

Screws

Figure 5 - Cylinder and Bulb Locations

Cylinder

Flame

Generation

Bulb

Ember Bed

Bulb

8. Secure the rear cover of the unit to the main

frame by reattaching the 6 screws remove in

step 1.

Replacing Ember Bed Bulbs

1. Unplug unit from the power supply.

2. Remove the six screws from the back of stove

as shown in Figure 5. Remove back plate.

3. Locate the ember bed light bulb in the bottom

of the unit shown in Figure 6. It is under the

ﬂame generation cylindrical drum toward the

front of the unit.

4. Remove spring clip. Hold socket and pull out

old bulb.

5. Hold socket and push in new bulb. Replace

spring clip.

6. Secure the rear cover of the unit to the main

frame by reattaching the 6 screws remove in

step 1.

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments