Desa VP1000BA User Manual download pdf (Page 11)

101869

Installing Two Mounting Screws

Note:

Wall anchors and mounting screws are in hardware package. The hardware

package is provided with heater.

Attaching to wall stud method

For attaching mounting screw to wall stud

1. Drill hole at marked location using 9/64" drill bit.

2. Insert mounting screw into wall stud.

3. Tighten screw until 1/16" space (thickness of penny) is between screwhead and

wall.

Attaching to wall anchor method

Follow instructions below to attach mounting screws to hollow walls (wall areas

between studs) or solid walls (concrete or masonry).

1. Drill holes at marked locations using 5/16" drill bit. For solid walls (concrete or

masonry), drill at least 1 1/4" deep.

2. Fold wall anchor (see Figure 6).

Figure 8 - Tightening Anchors

Thin Walls

(1/4" to 1/2" thick)

3. Insert wall anchor (wings first) into hole. Tap anchor flush to wall.

4. For thin walls (1/2" or less), insert red key into wall anchor. Push red key to

“pop” open anchor wings (see Figure 7).

IMPORTANT:

Do not hammer key!

For thick walls (over 1/2" thick) or solid walls, do not pop open wings.

Figure 6 - Folding Anchor

INSTALLING

TO WALL

Continued

Figure 7 - Popping Open Anchor Wings For Thin Walls

5. Tighten two screws until 1/16" space (thickness of penny) is between

screwheads and wall (see Figure 8).

ANCHOR

1/16" Space

Thin or Thick Wall

(thick wall shown)

Solid Wall

Continued

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

No comments

Desa VP1000BA User Manual Page 11