Desa C User Manual download pdf (Page 20)

104415-01L

For more information, visit www.desatech.com

Shutting Off Heater

1. Turn control knob clockwise to the OFF position.

2a. Set selector switch in the OFF position.

2b. If Using Optional Hand-Held Remote: Set selector switch

in the OFF position to prevent draining battery.

Shutting Off Burners Only (pilot stays lit)

You may shut off the burners and keep the pilot lit by doing one

of the following:

1. Turn control knob clockwise to the PILOT position.

2. Use remote control manual OFF button.

3. Set selector switch in the OFF position.

CAUTION: Do not try to adjust heating levels by

using the equipment shutoff valve.

WARNING: Make sure the selector switch is in the

OFF position when you are away from home for long

periods of time. Heater will come on automatically

with selector switch in the ON position.

OPERATING HEATER

Continued

1. Follow steps 1 through 6 under Lighting Instructions begin-

ning on page 19.

2. Depress control knob and light pilot with match.

3. Keep control knob pressed in for 30 seconds after lighting

pilot. After 30 seconds, release control knob. Now follow

steps 9 through 11, Lighting Instructions, column 1.

Figure 30 - Pilot (Propane/LP)

Ignitor

Electrode

Pilot

Burner

Figure 31 - Pilot (Natural)

Ignitor

Electrode

Pilot

Burner

OPERATING HEATER (REMOTE-READY MODELS)

Lighting Instructions (Cont.)

To Turn Gas Off To Appliance

Manual Lighting Procedure

MANUAL LIGHTING

PROCEDURE

TO TURN OFF GAS

TO APPLIANCE

5. Wait five (5) minutes to clear out any gas. Then smell for

gas, including near the floor. If you smell gas, STOP! Fol-

low “B” in the safety information, starting in column 2,

page 19. If you don’t smell gas, go to the next step.

6. Press in and turn control knob counterclockwise

to the PILOT position. Press in control knob for five (5)

seconds (see Figure 29).

Note:

You may be running this heater for the first time

after hooking up to gas supply. If so, the control knob may

need to be pressed in for 30 seconds or more. This will al-

low air to bleed from the gas system.

7. With control knob pressed in, press and release ignitor

button. This will light pilot. The pilot is attached to the

front burner. If needed, keep pressing ignitor button un-

til pilot lights.

Note:

If pilot does not stay lit, contact a qualified service

person or gas supplier for repairs. Until repairs are made,

light pilot with match. To light pilot with match, see Manual

Lighting Procedure.

8. Keep control knob pressed in for 30 seconds after lighting

pilot. After 30 seconds, release control knob.

• If control knob does not pop out when released, contact

a qualified service person or gas supplier for repairs.

Note:

If pilot goes out, repeat steps 4 through 8.

9. Slightly push in and turn control knob counterclockwise

to the ON position.

10. Wait one minute and switch selector switch to the ON posi-

tion to light burners.

Note:

AUTO is only functional when

using GWMT1 or GWMS2 optional accessories.

11. Set flame adjustment knob to any level between HI and LO.

AUTO

OFF

Figure 29 - Control Knob and Ignitor Button Location

Control Knob

Ignitor Button

Selector Switch

in OFF Position

Flame Adjustment

Knob

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

Comments to this Manuals

No comments

Desa C User Manual Page 20

Comments to this Manuals

Related products and manuals for Fireplaces Desa C