Desa RCP2000 User Manual Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 12
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
8
101283
5. If pilot light goes out, repeat step 4.
6. When pilot remains lit, fully open main burner valve. Do this by turning main
burner valve handle towards the ON position until it stops.
Note:
Arrows on
main burner valve handle show directions for ON and OFF.
7. Adjust main burner valve handle slowly towards the OFF position, for less
heat if needed.
MAINTENANCE
1. Keep heater clean.
2. Inspect heater before each use. Check connections for leaks. Apply mixture of
liquid soap and water to connections. Bubbles forming show a leak that must be
corrected. Correct all leaks at once.
3. Inspect hose/regulator assembly before each use. If hose is highly worn or cut,
replace.
4. Have heater inspected yearly by service person.
To Stop Heater
1. Tightly close propane supply valve on propane tank(s).
2. Shut off main burner valve. Do this by turning main burner valve handle
towards the OFF position until it stops.
Note:
Arrows on main burner valve
handle show direction for ON and OFF.
To Restart Heater
1. Wait five minutes after stopping heater.
2. Restart heater by following steps under “To Start Heater.”
STORAGE
1. Store propane tank(s) in safe manner. Refer to Chapter 5 of Standard for
Storage and Handling of Liquified Petroleum Gases, ANSI/NFPA 58. Follow
all local codes. Always store propane tanks outdoors.
2. Place plastic cover caps over brass fittings on inlet connector and
hose/regulator assembly.
3. Store in a dry, clean, and safe place.
WARNING ICON G 001
CAUTION
Disconnect heater from propane supply tank(s).
WARNING ICON G 001
CAUTION
Do not stack heaters over three high if more than one
heater is being stored. Secure heaters with rope or strap
after stacking.
WARNING ICON G 001
WARNING
Never attempt to service heater while it is connected to
propane supply, operating, or hot. Severe burns can occur.
WARNING ICON G 001
CAUTION
Do not operate heater at extremely low BTU (100% yellow
flame). This may cause sooting inside heater.
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments