Desa SPC-54PHT User Manual download pdf (Page 7)

www.desatech.com

114144-01D

ASSEMBLY INSTRUCTIONS

Continued

Figure 8 - Attaching Dome to Emitter

OPERATING

INSTRUCTIONS

WARNING: If you smell gas:

• Shut off gas to the appli

ance.

• Extinguish any open ﬂames.

• If odor continues, immediately

call your gas supplier.

See safety warnings and pre

cautions starting on the front

page of this manual for more

information.

PREPARING FOR OPERATION

1. Check heater for possible shipping damage. If

any is found, immediately notify the factory.

2. Follow all safety information.

3. Check and assure control knob is in the OFF

position.

DOME AND EMITTER

Gently lay heater assembly on its side using one of

the shipping styrofoam inserts to prop up the top

half of heater. Align holes in dome with threaded

studs in emitter cover. Secure dome to emitter

using three cap nuts. Tighten with an adjustable

wrench. Stand heater back to upright position.

4. Place propane/LP gas cylinder inside cylinder

base. Securely connect regulator to propane/LP

gas cylinder.

5. Turn cylinder valve on. Apply a soap and

water solution to connection at regulator and

cylinder. Bubbles forming show a leak.

6. In case of any leaks, turn off propane/LP cyl

inder valve, undo leaking connection. Check

and clean connection. Reconnect regulator and

leak test again.

START

1. Purge gas line leading to pilot assembly. Press

and turn control knob to HIGH position, keep

ing it pressed in for 1 to 2 minutes. Note: When

a new or reﬁlled gas cylinder is installed, heater

will need to be purged again.

2. To light the pilot:

a) Press control knob and turn to the PILOT

position.

b) Hold control knob in and press ignition

button until the pilot lights.

c) Keep control knob pressed in for 30 sec

onds to heat thermocouple.

d) Release control knob and pilot should re

main lit.

Note: To visually check ignition

of pilot, slide viewing hole cover to either

side (see Figure 9).

e) Once pilot ﬂame stays on, close viewing

hole cover.

CAUTION: Do not attempt

to slide the viewing hole cover

when the main burner is lighting,

operating or hot.

Figure 9 - Viewing Hole and Cover

Viewing Hole

and Cover

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Comments to this Manuals

No comments

Desa SPC-54PHT User Manual Page 7

Comments to this Manuals