Desa TD124 User Manual download pdf (Page 7)

www.desatech.com

120948-01A 7

ASSEMBLY

Continued

Figure 10 - Burner Installation

Figure 11 - Attaching Regulator Hose to

Burner Fuel Line

10. Inspect length of gas hose on bottom of

burner assembly for any cracks, cut, holes

or excessive wear. Do not use heater if

hose is damaged.

11. Sliding hose into upper pole, install burner

and reector assembly to base (see Fig-

ure 10).

12. Align hole in burner assembly pole with

hole in upper pole (see Figure 10). Secure

burner assembly to upper pole using a

wing bolt. Be sure to tighten wing nut

completely.

Align Hole

in Burner

Assembly

With Hole in

Upper Pole

Figure 12 - Connecting Regulator to

Propane/LP Gas Tank

13. Lift tank cover. Install regulator hose to

burner fuel line using wrenches provided

in hardware bag (see Figure 11).

14. Securely connect regulator to propane/LP

gas cylinder (see Figure 12). When con-

necting regulator assembly to tank valve,

hand tighten nut clockwise to a positive

stop. DO NOT use a wrench to tighten.

Use of a wrench may damage quick clos-

ing coupling nut and result in a hazardous

condition.

15. Open cylinder valve. Apply a noncorrosive

leak detection fluid to connections at

regulator. Bubbles forming show a leak.

16. If leaks exist, turn off propane/LP cylinder

valve. Disconnect leaking connection.

Check and clean connection. Reconnect

regulator and leak check again.

17. If no leaks are present, pull cover down

over tank and legs. Unit is now ready to

light.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Comments to this Manuals

No comments