Desa VSGF28NTE User Manual download pdf (Page 9)

www.desatech.com

113135-01A

INSTALLATION

Continued

IMPORTANT:

Vent-free heaters add moisture to

the air. Although this is beneficial, installing fire-

place in rooms without enough ventilation air may

cause mildew to form from too much moisture.

See Air for Combustion and Ventilation, pages 6

through 8.

IMPORTANT:

Make sure the fireplace is level. If

fireplace is not level, log set will not work properly.

CHECK GAS TYPE

Use the correct gas type (natural or propane/LP).

If your gas supply is not correct, do not install fire-

place. Call dealer where you bought fireplace for

proper type fireplace.

WARNING: This appliance

is equipped for (natural or pro-

pane/LP) gas. Field conversion

is not permitted.

ELECTRICAL HOOKUP

This fireplace has a blower assembly with an elec-

trical cord. The electrical cord is five feet in length.

You must locate fireplace within reach of a 120-

volt grounded electrical outlet. If not, you must

install an electrical outlet within reach of fireplace

power cord. The GA3555 outlet accessory may

be used for built-in installation when a blower is

installed.

INSTALLING HOOD

Install hood to rail already installed in fireplace as

shown in Figure 5. Use 3 Phillips screws provided.

Figure 5 - Installing Hood

Screw

Hood

Rail

ASSEMBLING AND ATTACHING

OPTIONAL PERIMETER TRIM

(Included with Mantel Accessory)

IMPORTANT:

If you are recessing the firebox in

a wall, do not attach trim at this time. See page 10

for built-in fireplace installation.

Note:

The instructions below show assembling

and attaching trim to fireplace.

1. Remove packaging from three pieces of trim.

2. Locate four screws, two adjusting plates with

set screws, and two shims in the hardware packet.

3. Align shim under adjusting plate as shown in

Figure 6.

4. Slide one end of adjusting plate/shim in slot

on mitered edge of top trim (see Figure 6).

5. Slide other end of adjusting plate/shim in slot

on mitered edge of side trim (see Figure 6).

6. While firmly holding edges of trim together,

tighten both set screws on the adjusting plate

with slotted screwdriver.

7. Repeat steps 1 through 6 for other side.

Tighten trim hanging screws (#10 x 6.25 shoul-

der) into holes in cabinets. Place the assembled

trim onto fireplace cabinet. Align hanging notches

on trim with hanging screws on side of fireplace

(see Figure 7). Push trim firmly into place, slid-

ing hanging notches over hanging screws.

Figure 6 - Assembling Perimeter Trim

Side Trim

Top

Trim

Slot

Mitered Edge

Slot

Shim

Set Screws

Adjusting

Plate

Figure 7 - Attaching Perimeter Trim to

Fireplace

Trim Hanging

Screws

Assembled

Trim

Hanging Notches

on Trim

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Comments to this Manuals

No comments

Desa VSGF28NTE User Manual Page 9

Comments to this Manuals

Related products and manuals for Stoves Desa VSGF28NTE