Desa SPC-54PHT User Manual download pdf (Page 4)

www.desatech.com

114144-01D

4

Installation and repair should be

done by a qualiﬁed service person.

The heater should be inspected

before use and at least annually by

a qualiﬁed service person. More

frequent cleanings may be required

as necessary. It is imperative that

control compartments, burners and

circulating air passageways of the

heater be kept clean.

CAUTION: The gas pressure

regulator provided with this ap-

pliance must be used. This regu-

lator is set for an output pressure

of 11" W.C. (2.74 kPa).

PROPANE/LP SAFETY

WARNING: For outdoor

use only.

ASPHYXIATION HAZARD

• Do not use this heater for heating human

living quarters.

• Do not use in unventilated areas.

• The ﬂow of combustion and ventilation

air must not be obstructed.

• Proper ventilation air must be provided

to support the combustion air require

-

ments of the heater being used.

• Refer to the Speciﬁcations, page 2, heater

data plate or contact DESA Heating Prod

-

ucts to determine combustion air ventila

-

tion requirements of the heater.

• Lack of proper ventilation air will lead

to improper combustion.

• Improper combustion can lead to carbon

monoxide poisoning leading to serious

injury or death. Symptom of carbon mon

-

oxide poisoning can include headaches

dizziness and difﬁculty in breathing.

Figure 1 - Base Assembly

Legs

ASSEMBLY

INSTRUCTIONS

Tools Required:

• #2 Phillips Head Screwdriver 1

• Adjustable Wrench 2

Inspect heater components for possible shipping

damage. If any is found, immediately notify the

dealer. Check to make sure that all components are

included with your heater (see pages 10 and 11).

POLE ASSEMBLY

1. Attach legs to base using two bolts, two lock

washers and two nuts (see Figure 1). Insert

bolts through legs and into top of base. Attach

lock washers and nuts from underneath base.

Finger tighten only. Repeat for each leg. Do

not fully tighten until next step.

2. Secure pole support to legs using two bolts,

two lock washers and two nuts. Repeat for

each leg. Wrench tighten nuts and bolts from

step 1 and 2.

3. Attach ballast weight to base using one, long

bolt, lock washer and nut (see Figure 1).

Base

Pole

Support

Ballast

Weight

SAFETY INFORMATION

Continued

1 2 3 4 5 6 7 8 9 ... 35 36

Comments to this Manuals

No comments