Desa CGS2718NA User Manual download pdf (Page 19)

www.desatech.com

113101-01C 19

LIGHTING

INSTRUCTIONS

WARNING:

• If ﬁreplace has glass doors,

never operate this heater with

glass doors closed. If you op-

erate heater with doors closed,

heat buildup inside ﬁreplace

will cause glass to burst. Make

sure there are no obstructions

across openings of ﬁreplace.

• You must operate this heater

with a fireplace screen in

place. Make sure fireplace

screen is closed before run-

ning heater.

NOTICE: During initial operation

of new heater, burning logs will

give off a paper-burning smell.

Orange ﬂame will also be pres-

ent. Open damper or window to

vent smell. This will only last a

few hours.

Note: Home owners generally prefer to op-

erate their heater with the chimney damper

closed. This will put all the heat into the room.

However, there may be times you will desire

the full ﬂames of the HI heat setting but will

ﬁnd the heat output excessive. You can open

the chimney damper (if you have one) fully or

partially to release some of the heat.

WARNING: Damper handle

will be hot if heater has been

running.

1. STOP! Read the safety information page 18,

column 2.

2. Make sure equipment shutoff valve is

fully open.

3. Press in and turn control knob clockwise

to the OFF position.

OPERATING HEATER

Continued

4. Wait ﬁve (5) minutes to clear out any gas.

Then smell for gas, including near the ﬂoor.

If you smell gas, STOP! Follow “B” in the

safety information page 18, column 2. If

you donʼt smell gas, go to the next step.

5. Slightly depress and turn control knob

counterclockwise

to the PILOT

position. Press in control knob for ﬁve (5)

seconds (see Figure 26).

Note: You may be running this heater for

the ﬁrst time after hooking up to gas sup

-

ply. If so, the control knob may need to be

pressed in for 30 seconds or more. This will

allow air to bleed from the gas system.

6. With control knob pressed in, press and

release ignitor button. This will light pi

-

lot. The pilot is attached to the burner. If

needed, keep pressing ignitor button until

pilot lights.

Note: If pilot does not stay lit, contact a

qualiﬁed service person or gas supplier for

repairs. Until repairs are made, light pilot

with match. To light pilot with match, see

Manual Lighting Procedure, page 20.

7. Keep control knob pressed in for 30 seconds

after lighting pilot. After 30 seconds, release

control knob.

Note: If pilot goes out, repeat steps 3

through 7.

• If control knob does not pop out when

released, contact a qualified service

person or gas supplier for repairs.

8. Slightly depress and turn control knob coun

-

terclockwise

to desired heating level.

The burner should light. Set control knob

to any heat level between HI and LO.

WARNING: Do not operate

heater between PILOT and HIGH

positions.

Figure 26 - Control Knob and Ignitor

Button Location

PILOT

OFF

LO

HI

Ignitor Button

Control Knob

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

Comments to this Manuals

No comments