Desa A User Manual download pdf (Page 16)

101048

Installing Bottom Mounting Screws

1. Locate two bottom mounting holes. These holes are near bottom on back panel

of heater (see Figure 17).

2. Mark screw locations on wall.

3. Remove heater from mounting bracket.

4. If installing bottom mounting screws into hollow or solid wall, install wall anchors.

Follow steps 1 through 4 under Attaching To Wall Anchor Method, page 15.

If installing bottom mounting screw into wall stud, drill holes at marked loca-

tions using 9/64" drill bit.

5. Replace heater onto mounting bracket.

6. Place spacers between bottom mounting holes and wall anchor or drilled hole.

7. Hold spacer in place with one hand. With other hand, insert mounting screw

through bottom mounting hole and spacer. Place tip of screw in opening of wall

anchor or drilled hole.

8. Tighten both screws until heater is firmly secured to wall. Do not over tighten.

Note:

Do not replace front panel at this time. Replace front panel after making

gas connections and checking for leaks (see pages 21-23).

INSTALLATION

Continued

B. MOUNTING HEATER ON OPTIONAL HEARTH BASE

Tools needed: #2 Phillips screwdriver, slotted screwdriver, and electric drill (if

securing base to floor)

The optional hearth base kit includes the following:

Hearth Base 4 Wood Screws 4 Sheet Metal Screws Brass Base Trim

Hearth Insert 4 Anchors Laminate Sheet 2 Brass Screws

Note:

If securing hearth base to floor, follow instructions under Securing Hearth

Base to Floor, below. If not securing hearth base to floor, proceed to Mounting

Heater to Optional Hearth Base, page 17.

Securing Hearth Base to Floor

1. Position hearth base in desired location. Mark holes for drilling (See Figure 18,

page 17). Remove hearth base.

2. For carpeted floor, make a small cut with a sharp knife at marked locations

before drilling.

If securing to a wood floor, drill a 3/4" deep hole using a 1/8" diameter drill bit.

Do not use anchors in wood floors.

If securing to a concrete floor, drill a 1 3/8" deep hole using a 1/4" diameter

concrete drill bit. Completely insert anchors into each hole.

3. Mount heater to hearth base following steps under Mounting Heater to Optional

Hearth Base, page 17. After mounting heater, position heater and hearth base

over drilled holes. With slotted screwdriver, secure hearth base to floor with

four wood screws.

Figure 17 - Installing Bottom Mounting Screws

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Comments to this Manuals

No comments

Desa A User Manual Page 16

Comments to this Manuals

Related products and manuals for Radiators Desa A