Desa SPC-54PHT User Manual download pdf (Page 6)

www.desatech.com

114144-01D

6

ASSEMBLY INSTRUCTIONS

Continued

CHECK FOR LEAKS

IMPORTANT: The heater must be leak tested be-

fore any further assembly is done. Use only a soap

and water solution. DO NOT USE FLAME.

Turn control knob to the OFF position. Securely

connect regulator to propane/LP gas cylinder.

Open propane/LP cylinder valve. Apply a soap

and water solution to connections at the manifold,

burner, and control assembly. Bubbles forming

show a leak. In case of any leaks, turn off pro

-

pane/LP cylinder valve, remove manifold, check

and clean connection. Reconnect manifold and

leak test again.

Upon completion of leak test, and when there is

no sign of a leak, turn off propane/LP cylinder

valve and disconnect regulator from propane/LP

gas cylinder. Remove propane/LP gas cylinder and

continue to next step.

POLE AND BURNER/CONTROL

ASSEMBLY

Attach pole to burner and control assembly (see

Figure 6). Align the three holes. Insert a small

bolt in each hole and tighten using #2 Phillips

head screwdriver.

MANIFOLD FIXING PLATE AND

POLE SUPPORT

1. Locate threaded hole underneath post support.

This hole is for mounting manifold ﬁxing plate

(see Figure 7).

2. Align holes on manifold ﬁxing plate with

threaded holes on pole support.

3. Make sure manifold ﬁxing plate is facing

downward see (Figure 7).

4. Use a bolt to tighten manifold ﬁxing plate to

post support using #2 Phillips head screw

-

driver.

5. Turn manifold ﬁxing plate so it will hold

manifold in place.

6. Tighten bolt so manifold ﬁxing plate will not

move.

Figure 6 - Attach Burner and Control

Assembly to Pole

Manifold

Fixing Plate

Figure 7 - Attaching Manifold Fixing

Plate to Post Support

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

Comments to this Manuals

No comments